Ford 1310, 1510, 1710 10 Series Tractor Repair Manual 40131020 (SE4301) English
Brands: Ford / New Holland Agriculture
Equipment Type: Tractor
Manuals Type: Repair Manual
Machine Model & Serial Number: 1310, 1510, 1710
Region: N/R
Book Code: 40131020 (SE4301)
Issued: Issue 5-84 (Revised 6-86)
Language: English
Pages: 556
File Format: Portable Document Format (PDF)
Remark: The absolute 555-page factory repair manual for the Ford 10 Series compact tractors. Nuclear Level Value: This technical compendium provides exhaustive overhaul protocols for the S753, K773, and H843 diesel engines. Features surgical deep-dives into synchromesh transmission rebuilds, double clutch adjustments, and the specialized triple reduction axles for the 1710 Offset variant. Contains complete hydraulic flow logic for the I.C. Controlled position systems and full-chassis wiring schematics for all listed horsepower ranges.
Table of contents
- SECTION 0 - INTRODUCTION AND SAFETY
- Production Date Codes and Serial Numbers
- Safety Precautions
- General Service Techniques
- PART 1 - ENGINE SYSTEMS
- Engine and Lubrication System
- Description and Operation
- Cylinder Head Removal and Disassembly
- Valve Seats, Guides, and Springs Inspection
- Pistons and Connecting Rods Service
- Cylinder Block Boring and Reconditioning
- Crankshaft and Main Bearings Reconstruction
- Cooling System
- Water Pump Overhaul
- Thermostat Testing
- Troubleshooting, Specifications, and Special Tools
- Engine and Lubrication System
- PART 2 - FUEL SYSTEM
- Diesel Fuel System
- Injection Pump Removal and Timing
- Spill-Timing Procedures
- Governor Linkage Rebuild
- Injectors Overhaul and Pressure Adjustment
- Fuel System - Model 1710 Offset
- Diesel Fuel System
- PART 3 - ELECTRICAL SYSTEM
- Wiring, Switches, and Glow Plugs
- Starting System Overhaul
- Charging System Bench Tests
- PART 4 - CLUTCHES
- Single Clutch Overhaul
- Double Clutch Disassembly and Adjustment
- PART 5 - TRANSMISSION SYSTEMS
- Non-Synchromesh 12x4 Transmission Overhaul
- Synchromesh 12x4 Transmission Overhaul
- PART 6 - POWER TAKE-OFF SYSTEMS
- PART 7 - DIFFERENTIAL, REAR AXLE AND BRAKES
- Differential Backlash Adjustment
- Rear Axle Shaft Overhaul
- Triple Reduction Rear Axle (1710 Offset)
- PART 8 - HYDRAULIC SYSTEM
- Control Valve Disassembly
- Lift Cylinder and Piston Seal Replacement
- Hydraulic Pump Service
- I.C. Controlled Mid-Mounted Position Control
- PART 9 - STEERING SYSTEMS
- Manual Steering Gear Adjustment
- Power Assist Steering Overhaul
- PART 10 - FRONT AXLE AND RELATED PARTS
- PART 12 - SEPARATING THE TRACTOR
Professional Surgical Insight
When overhauling the H843 engine, measuring piston protrusion is vital to select the correct cylinder head gasket thickness to maintain the precise compression ratio. For the double clutch assembly, the PTO release bolt clearance must be set exactly to 0.035-0.039 inches to ensure clean disengagement. On the 1710 Offset, the triple reduction gears in the rear axle require specific bearing preload settings to prevent gear face scoring under heavy side-loads. Always verify the I.C. Control depth sensor resistance (400-600 ohms) before performing hydraulic linkage adjustments.